Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

logic

  1. D

    Ideal logic no hot water

    just wondered if any damage to the flow sensor could take out the pcb on an Ideal Logic. Can anyone advise please.
    • dawgas
    • Thread
    • hot water ideal ideal logic logic water
    • Replies: 5
    • Forum: Bathroom Advice
  2. Riley

    Is my logic reasonable here

    Evening gents I have been unfortunate enough to pick up a job from where a builder has scarpered when he couldn't get any of the plumbing to work. I thought I had it all licked but today the customer has come back to me telling me that the new thermostatic mixer bar is only coming out...
  3. C

    ideal logic heat 24 not firing

    Am in need of some advice please. My boiler stopped working 10 days ago showing error code fd (no flow), new flow sensor, pump, pcb, a power flush, 3 plumbers & £600 later we're still at fd and boiler not firing up past 4 seconds. Even speaking to ideal they're scratching their heads. Its...
    • cookiecat
    • Thread
    • heat ideal ideal logic logic
    • Replies: 2
    • Forum: UK Plumbers Forums
  4. C

    Ideal logic / indenpent L2 fault code

    Have L2 lock out on a logic, anyone who work on these have any common causes of L2 on them doesn't even try to fire up then lock out as far as the customer says? thanks in advance :)
  5. A

    Ideal Logic gauges

    Serviced 3 Logic+'s today, two of which when the heating is running or the pump over run is on after demand, the pressure gauge needle is rattling about so much it is actually noticeable from within a 3m range from the boiler. Luckily ones in a cupboard so that drowns out the rattle, but the...
  6. C

    ideal logic heat 24 not playing ball

    Heat & hot water stopped 2 days ago, boiler flashing fd. Followed trouble shooting in manual and ordered a new water flow sensor. Was replaced today, still no blue light and still flashing fd. New plumber called, he replaced pump and told us to bleed rads and all will be fine. 5 hours later...
    • cookiecat
    • Thread
    • heat ideal ideal logic logic
    • Replies: 1
    • Forum: UK Plumbers Forums
  7. E

    Ideal logic heat 15

    Went to service logic heat 15 today with complaint of L2 showing and having to reset to get it going . Hadn't been serviced in five years from new ... The heat exchanger and siphon were gunged up with aluminium oxide sediment , cleaned thoroughly., cleaned spark and sensor probes ,checked flow...
  8. C

    Ideal Logic Combi 35 F-1 error with pressure on gauge

    Hi all, New to the forum. Last night, while running hot water from our Logic Combi 35 boiler the front display started displaying F-1 and stopped producing any hot water. Of course this usually means low pressure, however the gauge is showing 2.5Bar. There is plenty of pressure at the hot...
    • cmacinnes86
    • Thread
    • combi ideal ideal logic logic pressure
    • Replies: 2
    • Forum: UK Plumbers Forums
  9. A

    Ideal logic gas valve

    Can the ideal logic gas valves be adjusted? Couldn't see anything in the manual. I've got one to go to that's making a baffling noise.

We recommend City Plumbing Supplies, BES, and Plumbing Superstore for all plumbing supplies.

Featured Content

Back
Top