any done much with these as got two in series in a pub
readings im having doubts about
propane (lpg)
o2: 11.3%
co2: 6.87
Co: 0ppm
Ratio: 0.0000
eff: 88.6%
Ex Air 117%
Draught: -0.260
manual doesnt list any spec regarding readings
ex air im sure is too high
am i missing something
I was originally called to this as the pilot was going out.
I changed tthermocouple and then the boiler would not light the burner when the hot tap was switched on.
I suspected the diaphragm.
This was ok, but on checking the gas valve below the burner. Water had leaked into it from the...
hello every one, newby here, I've done a bit of DIY plumbing in the past (Trained Aircraft Engineer so use to hydraulic and pneumatic systems) and have a question relating to bathroom waste water going down the main down pipe.
At present the waste water pipe to the main down pipe runs above the...
glow worm hxi30 boiler f9 fault code. no low water pressure switch on this boiler.and blown fuse second on pcb (does tis mean board gone?) main board
pump external to boiler. grundfos 25-80
slight history of job, arrived to fit dual fuel cooker gas hob electric oven. fitted
connect l.N.E to...
Can an existing flue from a Main 24he be used on a new Duotec
I know the position is different, but this isn't an issue
BTW, flue is good
Sec hex leaked condense on to primary and rotted it, £500 + for both hexs plus labour
New boiler time
Hi guys,
I have been bleeding my radiators due to a small airlock that was present and the boiler pressure has subsequently dropped down. Looking underneath, I am unsure as to how to re-pressurise, doesn't seem to have the fittings as described in the manual. I have the braided filling loop...
got to connect up to old steel pipe, it looks like 3/4 pipe to me.
what is the best option to connect to? copper? plastic?
any help would be great
its being buried too
Good Morning Everyone,
I have a Glow Worm 30cxi Condensing Combi Boiler.
Last week, the main pcb died. I got the board replaced (4000124180). Boiler came back on, happy days.
I did notice that the water was nowhere near as hot as it should be and been advised the Plate to Plate Heat Exchanger...
Job tonight
Went to see said boiler that was not firing. I reset the boiler and pump runs micro switch makes but fan does not run and boiler doesn't fire. It flashes flame symbol and fan symbol. I have checked for 240 at fan which I'm not getting and 240v from pcb at fan harness but 0v . I...
Job I'm looking at tomorrow
Heating just been switched on for first time, an basically the temperature is flying up to 90 an switching off.
Getting some heat on flow, an the pump seems to be working OK.
A hose has been attached to a drain off down stairs to try to drag heat away from...
righto, I dont do much of this, usually stick to heating and boilers but... its my mums place so I better get on ;)
her stopcock is wiped onto lead and is leaking and I gotta repair.. I know using a taft or any lead joint etc is a no no now so was planning to use a Philmac universal coupling...
Just about to have a new 25mm mains supply buried to the road and need a brass stop tap to connect to the MDPE pipe and wondered if there were any recommendations for a good quality tap that hopefully won't restrict any flow.
It has to be a 25mm MDPE to 22mm copper and looking at some taps it...
I was wondering if i could get a bit of advice, I've got a Main 30 elite combi and it's not switch over to the central heating from the hot water and after reading a few threads on here i came to the conclusion that it could be the diverter valve so decided to get a repair kit off ebay.....
I...
jonnyg
Thread
central
central heating
combi
heating
hot water
main
water
Replacing an external water main and Scottish water will be inspecting it after I'm done, I'm tryin to find insulation but have had no luck, the type that's in a duct you can put over pipe for when it enters property and where a minimum of 750mm can't be achieved.
Does anyone have copy of the BS?
Hi I'm after some advice re my main combi 30 he boiler
in the past I've had issues with the condensate drain becoming blocked but after cleaning it out a number of times I know that this is not the problem now.
I've reset the boiler a number of times but it won't work so no heating or hot...
Hi all, i have a main multi ff water heater. When running all is well for about 5 mins, then no hot water and red light flashes. I think it is a combustion air problem. I have check the flue and it is clear, the 86mm restrict or plate is fitted as required and there is plenty off room around the...
Hi.
Just found this forum and hope someone can help.
I've just moved in to a new house a few months back and have found that under the kitchen sink water is collecting on the mains water pipe. A plumber from Homerserve said that its condensation since he could not find a leak. He's told me to...