Good morning,
Can someone help me please? I've had my kitchen extended and was advised by my builder to buy a Vaillant ecotec plus boiler as it would be able to accomodate at least 20 radiators (I now have 7 and a heated towel rail). The plumber came in and attached a hose pipe to the radiator...
boiler turning on when no call for heat. hot water or central heating all four motorized valves are shut down boiler heats to 60 + then goes in to recycling mode as it got to hot then some times it goes to f20 which is high limte cut out vaillant said to remove the 24v link (rs) but the boiler...
Hi, I attended a Ideal Logic Plus 24 today and although there was no fault code, the DHW was reaching a max of 52 degrees. Looking at the service book it doesn't have a DHW thermistor. Can anyone please tell me what regulates the temperature? Thanks
So, recently had the Vaillant 350f thermostat replaced with a Nest and I'm left with a problem I can't wrap my head around. Boiler is Vaillant ecoTec 831 Plus and is only a couple of years old.
With the Vaillant thermostat, the flow temperature would vary based on room temp vs set temp, but...
I have a few questions regarding common issues on the 824 r1
Expansion v flat so re charged n holding
Flow hot n returns good
It has the rubber hose at both rear ends
Is the vaillant with main heat exchanger issues and was there a fix for the rubber hose or is this down to the owner as they...
Hi Guys, just after some advice if someone could help.
I have a Aerocyl plus unvented cylinder in my house, Heat pump external (no gas)
I have a steady flow of cold water though the pressure relief tundish. Its constant as far as I can tell.
Going to call out a plumber tomorrow but in the...
Hello, I don't know if anyone can help. I have a 3 year old boiler that had been working fine but now everytime it turns off it doesn't turn back on but stays in standby with one dot. The timer works okay and says it is asking for heat but the boiler stays in standby. If I turn the boiler off at...
Hopefully someone can offer best course of action!
have slow pressure loss of approx 0.5 bar over 1 week on the title boiler above.
Have british gas homecare and they have now visited 3 times without finding cause of problem.
first two visits they just re-charged expansion vessel and...
Hi,
Can anyone please help or offer an opinion?
My Baxi 133 HE Plus has had issues for some time now and several plumbers have not been able to fix.
Historically the boiler has had new heat exchanger (about 1-2 years ago, although has recently been cleaned/descaled), new pump (1 year ago)...
Have a customer who's been having issues with the boiler going to A1 lockout, usually noticing the problem when using HW, mainly in the shower, running hot and cold. They've had WB out who have changed the gas valve and the plate HEX, also 2 thermistors. However, the major problem seems to be...
It's not going above 42 degrees. Burners on. Have checked thermostat and it's working fine. It ramps up every now and temp goes to 65 degrees for about 10 seconds and then ramps straight back down and temp goes back to 42...????
Didn't go as far as to check the thermistor as it was bloody late...
It's not going above 42 degrees. Burners on. Have checked thermostat and it's working fine. It ramps up every now and temp goes to 50 odd and then ramps straight back down and temp goes back to 42...????
Heating & Gas Engineer
QERB Energy currently require an experienced engineer to carry out boiler and heating installation, servicing and maintenance (mainly Vaillant) in the Bristol and Bath area.
The successful applicant will have experience in the following areas;
Domestic Gas Boilers...
Hi I am new to this and not sure how to put up a pic without it saying denied.I am unsure how to connect the nest heat link to this combi. Any advise would be great
can't test the boiler in full rate as when selected it doesn't respond, doesn't respond to anything in the p menu
board fault i presume. going back tomorrow, anyone had this before?
HI everyone
Had my new boiler about 4 months... it's a vaillant ecotec plus 838...
Today I noticed some browning on the white plastic cover looks like could be water marks... or some sort of lacker issue...
Anyone seen something like this before?