Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws
It is a new installation. The threaded drain off valve hasn’t been installed. I have the G3 qualification. But have only done the course recently and haven’t worked on my first cylinder yet. So I am just checking before I fit the drain off valve. I would normally use 3 to 4 wraps of PTFE tape. Thanks
Just enough to seal and not too much to make it difficult.
It's a mystic art.
And dont forget the paste.
It's a mystic art.
And dont forget the paste.
I do 10-12 wraps and see if I can screw the fitting in by hand alone. If I can't I put the tools on it and do it all the way up. If I can do it up almost all the way by hand, I carefully unscrew it so as not to shred the tape up on the fitting and add another 5 or 6 wraps.
I used to always clean all the PTFE off and start from scratch, just adding more wraps of tape and give it another go if it didn't feel right or leaked. Then an old plumber told me to try what I describe above and I have had much more reliable joints ever since.
As Simon G says, it is a bit of a mystic art too and something you just get a feel for. Also plumbers like to disagree on the best way to do such things so anyone please feel free to disagree with my method! It works for me very reliably that's all I can say.
Now on to paste or no paste.......😵
I used to always clean all the PTFE off and start from scratch, just adding more wraps of tape and give it another go if it didn't feel right or leaked. Then an old plumber told me to try what I describe above and I have had much more reliable joints ever since.
As Simon G says, it is a bit of a mystic art too and something you just get a feel for. Also plumbers like to disagree on the best way to do such things so anyone please feel free to disagree with my method! It works for me very reliably that's all I can say.
Now on to paste or no paste.......😵
I have had to use a 1/2" BSP tap to sort out the threads on some cheapo towel rails before. When the tappings are that bad it does become difficult to know how much tape will seal them. The again my method has worked fine on those ones too, especially after running the tap through them to clear the threads.
Some radiator tails are taper thread though. On the parallel ones, do you recommend using a string type sealer? I suppose good old hemp and paste would work on a parallel thread well too?
Everything I’ve seen in in UK domestic plumbing and heating has been BSP parallel, some of the wiser guys in here may know better. I guess you have more NPT stuff on the US?
You can often get away with PTFE because the pressure is low. Your generally recommended to use an anaerobic thread sealant like Loctite 577. You can get an activator to speed up the cure time.
Official Sponsors of Plumbers Talk
Similar plumbing topics
- Question
- Question
- Question
- Question
We recommend City Plumbing Supplies, BES, and Plumbing Superstore for all plumbing supplies.
