How much would you charge....

[Inverness]

on a Worcester greenstar 30si to replace new expansion vessel and a new prv, which means to remove the hydroblock nightmare of a job. The prv lever is loose it does not operate which needs replaced.
I'd like to know roughly the labour you would charge so I don't under rate myself.

 

[Sharp Point]

Easiest way to do this, would be get a bag of 1/2 and 3/4 washers. Undu the top nuts off the valves, remove the flue and lift the boiler off the jig.

 

[Aire]

Easier to remove the boiler to be honest, will take you around 2 hours plus travel etc, depends where you are but id be looking around £100 for Labour.

Which is apparently optimistic 😀

 

[Sharp Point]

If not, you’ll need all the seals to start stripping the hydro components out of the boiler.

 

[Sharp Point]

I’d allow myself a morning or afternoons work to do it and an hour getting bits and pieces from the merchants.

 

[king of pipes]

I have worked on these better to remove the boiler fit new seals allow 4hrs check flue seals also they stretch and become out of shape £250 + parts . Kop

 

[Rob Foster]

uck repairing boilers , its a nightmare , there are sometimes no winners , the job and parts can cost almost as much as half a new one, it has to be carried out I know but its a nightmare for all
Rob Foster ..chking

 

[Sharp Point]

uck repairing boilers , its a nightmare , there are sometimes no winners , the job and parts can cost almost as much as half a new one, it has to be carried out I know but its a nightmare for all
Rob Foster ..chking

Lol, it’s divides the wheat from the chaff. I personally like to repair, it’s very satisfactory fixing something.