Guest viewing is limited

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

View the thread, titled "Salus IT500 and baxi 636 compatable ?" which is posted in Central Heating Forum on UK Plumbers Forums.

Hi all,
Decided to get the Baxi 105 replaced. Going for the baxi 636. My question is, will my current salus iT500 be compatible with the 636 as there doesn’t seem to be a 0v switching contact. I don’t have a 230v wired thermostat and the salus uses 0v switching. I don’t believe the iT500 is opentherm so would this still work in terminal 1&2 of the low voltage m2 terminal block or will I need to add a new wireless controller to the list !!
 
Tbh it doesn’t comply with boiler plus so your installer should of advised you on this

I fit eph combi pack 4

They asked what controller I had and showed them the iT500. I like this one as wifi enabled so can control from outside home if I’m out later etc. I will ask about hive or nest for a new wifi compatible programmable controller. I am going to get the baxi ifos installed with the boiler

Thanks for reply 👍
Roseyp
 
Either will be fine also your salus will fit volt free means the relay isn’t Powered eg low voltage but mains voltage is ok for it as well
 

Official Sponsors of Plumbers Talk

Reply to the thread, titled "Salus IT500 and baxi 636 compatable ?" which is posted in Central Heating Forum on Plumbers Forums.

We recommend City Plumbing Supplies, BES, and Plumbing Superstore for all plumbing supplies.

Weekly or Monthly Email Digest

Back
Top