- Messages
- 367
right, when I'm bending offsets I make the first angled bend, usually 45 degrees then I measure from the straight end section across the distance of the offset I require, then I add an additional 20mm and mark the pipe around.
then Its back into the bender to make the offset, I lower the wheel onto the pipe and place it on my mark.
line everything up and make the second 45 degree bend.
that works for me but its a faff, anyone got a better solution ?
then Its back into the bender to make the offset, I lower the wheel onto the pipe and place it on my mark.
line everything up and make the second 45 degree bend.
that works for me but its a faff, anyone got a better solution ?