Search the forum,

ContractorForum: how should you pick a tiler: should we allow the title of TILER to b

Post new thread

Discuss ContractorForum: how should you pick a tiler: should we allow the title of TILER to b in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Status
Not open for further replies.

Reply to ContractorForum: how should you pick a tiler: should we allow the title of TILER to b in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
215
dreikher
dreikher
A
Emergency Stop Buttons in Boiler Rooms
We are from Alberta, and I own an electrical company. I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the man-door to the boiler room. It's intent is to 'halt' the operation of the boilers in the room should there be an emergency. He is demanding that I do...
Replies
5
Views
291
oz-plumber
O
Lou
Show us your fanciest radiators you have installed!!
Show us your fanciest radiators you've installed! We would love to see them! I love this Milano vertical radiator in the kitchen space. What do you think?
Replies
4
Views
230
Timmy D
T
johndave
Outdoor stopcock doesn't fully close
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
292
exedon2
exedon2
127bit
How to reinforce shower pan threshold?
The left rear floor corner is highest (the shower pan touches/sits on the floor), sloping down diagonally to the front right corner (lowest). The front right corner shim is 5/8", the left front corner is 3/8" shimmed, with shorter shims under left middle and right rear corner. The pan perimeters...
Replies
6
Views
221
127bit
127bit
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tiling Forum
Tiling Advice
Tilers Forums UK
UK Tiling Forum
Tilezine Tiling News Tile Association
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock