Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

bath

  1. Rooo77

    L shape bath fitting advice.

    I've been doing the whole bathroom up and about to fit an L shaped acryclic bath, i'm going to baton each end of the wall and the against back wall to support it, will i need to frame / uprights the front of it, or will the gloss finished mdf panel be enough? The bath itself has wooden blocks...
  2. E

    Pop Up Bath plug sticking

    Hi Our pop up bath plug is sticking, looking for suggestions to fix it please. Wondering if WD40 might stop it sticking or will I need to replace a part? Many thanks.
  3. W

    lukewarm water in shower and bath issue?

    Hi, I have valiant combi boiler I'm getting hot water from my kitchen tap and hot water from my bathroom sink tap however lukewarm water from the shower and bath. The only difference with the bath and shower supply is that the pipes are run upwards into the ceiling of the bathroom and down to...
  4. D

    Fixed shower head off centre of bath

    Hi, I've recently ripped out a full bathroom and am replacing it with new everything. The old bath was P shaped with a fixed shower head coming from the wall. I've replaced the mixer shower but the dimensions of the new shower were identical to the old so the pipework was in the correct place...
  5. A

    Combined bath/shower wastes

    Hi. If I want to connect bath and shower wastes so they come out of the same pipe to the soil stack, what size does it have to be? 50mm? I've read that I need and anti-syphon valve too, as the shower waste run will be over 2 meters, under the bath. Do the bath and shower wastes have to be 40mm...
  6. P

    Where can I buy this bath plug?

    Hi, I have removed a seized bath plug from my bath, but would like any advice about how to go about finding a replacement. Please see attached photos. It just sits in the plug hole. The mechanism is spring loaded. If you push it down, it closes the hole and the top disk sits flush against the...
  7. F

    Hot feed from twin pump stalls when cold feed starts in bath mixer tap

    Hello All, Hoping for a bit of advice/info in this one: My Setup Small system in apartment with cold tank above hot tank in the hotpress, so fairly low head pressure. Installed a pump about 15 years ago and worked fine until last week (original pump was an Stuart Turner ST55 replaced after...
  8. G

    Bath mixer tap identification

    Bath mixer tap manufacturer identification I have a drip on the cold side of my quarter turn bath mixer. I cant isolate the feed as the isolation valves were installed face down against the floor! If some kind soul could identify the make/manufacturer I could source a new cartridge. My guess is...
  9. H

    Is this bath faulty? split layers

    Hi everyone! I have been reading this forum for quite a while now, but posting for the first time. I am doing a renovation in my bathroom, have received my acrylic bath today and I can see on the waste hole that the acrylic layers are split and it created like an air layer inside the bath base...
  10. A

    Bath tap too fast for the boiler?

    I have a Viessmann boiler 100 35Kw. When I turn the bath tap on full the water comes out cold. If I turn it down the water comes out hot. The tap flow rate is 12 litres per minute. Why can't my Viessmann boiler cope with that? Does it need a new part? Thanks
  11. nick555

    How to move bath tub drain pipe

    Hi all. We’re renovating a bathroom and have found the new bath tub drain needs to be closer to the wall than the current drain is. Tub drain fits left to right but the new drain is about two inches closer to the wall than the old tub. Have attached pic of the current drain. Looking for...
  12. uksoundz

    Help with unblocking whirlpool bath

    Hi I have these air jets in the base of my bath and when I switch the pump on only one works, it started working and lots of grime came out so I suspect all are blocked Does anyone know of a way to clean these and remove them? I’ve tried myself to no avail. Also; interestingly when I...
  13. L

    Broken jumper on bath tap

    Hi, we have an old Howard bird mixer bath tap Edwardian brass style. The jumper on one tap first snapped and now has broken off completely. Can't replace tap as the landlord decided it was a good idea to completely tile the bath in when the bath got fitted about 50 years ago. Landlord is...
  14. C

    Is it ever normal for a new bath to drain really, really slowly?

    Hi - I have just had a bath replaced during a bathroom renovation and the plug is now in the centre of the bath rather than at the end. It also now has a pop-up waste. The bath used to drain normally but after replacement, the bath drains very, very slowly, even when I unscrew and remove the...
  15. B

    Bath tap hot water not heating

    Hi everyone, I had my gas combi boiler serviced last month and the engineer completed the job, filled out the paperwork and said it was in good shape as it is just over 2 years old. Today I ran the hot water tap in the bathtub and it was lukewarm (36 degrees Celsius), I checked the kitchen and...
  16. S

    Flexible Waterproof Upstand Bath/Shower Seals -What's the best?

    Flexible Waterproof Upstand Bath/Shower Seals -What's the best Classi-Seal, Sealux AquaStrap, MX Flexi-Seal Strip? They all look to do the job, although the adhesive part of MX Flexi-Seal Strip looks smaller........... Any thoughts, ease of use, what have others used?
  17. A

    Plumbing & Heating Bath, Bristol, Taunton, Somerset | ADS [Deleted]

    adsplumbing submitted a business listing in the plumbers directory: Plumbing & Heating Bath, Bristol, Taunton, Somerset | ADS - Plumbing & Heating Checkout this business listing... - Please leave a review for this company if you have used them before. You can add your own plumbing business to...
  18. P

    Why no access to bath taps / low bath tap temp

    Hi, recently moved into new house, (the house is four years old), the bath has very low hot water temperature, I'm assuming its an anti scald device? The hot water in the rest of the house is fine, eg kitchen sink, utility sink, bathroom wash hand basins, etc, they all get nice and hot, its just...
  19. N

    Connect tap to shower hose or bath tub tap

    Hi, I'm hoping to connect a tap to either the bath tub tap (M28 I think?!) or alternatively the shower hose of the shower in the same bath tub. I need this tap for a small diy sink to sit on top of the bath tub for our toddler (as on this website: Kleiner Nachtrag zur Waschstation -...
  20. T

    Connector for combined bath overflow and supply

    I need advice on a water inlet pipe for a combined bath overflow and supply. I have uploaded photos. On one side is the attachment i need. In the attached pics one side of the fitting has the connector I need. It's missing from other side. Also how do you remove the fitting on left side? Looks...

We recommend City Plumbing Supplies, BES, and Plumbing Superstore for all plumbing supplies.

Featured Content

Back
Top