I have a solar powered water heater, on some days its extremely loud for a few hours.
Most days it's silent and there's no noise when the sun goes down.
First video is with the cover on when it's making the most noise
View: https://youtu.be/AgFyb34Ej9s
Second video when it calms down a...
Hi,
I'm replacing a 14" copper immersion heater installed into a Fortic hot water cylinder. The heater failed after just three years.
Hoping to get more life out of the next one, I've ordered an Incoloy, but am wondering whether to go for the titanium instead. It's only an extra couple of...
Hi can anyone tell me how I can remove the pipe fitting from the connection. Is it the silver nut above the isolator valve I need to undo or the brass nut just above the pipe connection.
Thanks
Hello.
I notice several tankless water heater units being sold Ebay.
Some of the listings show these units fitted under sinks and connected directly to the hot side of a mixer tap.
I had been under the impression, that units such as these required an open vent on the outlet side of the...
Anybody know local firm in Edinburgh Scotland who can carry out a service to a gas patio heater. Tried out the usual cleaning of pilot etc but burner ignites for minutes and starts giving a roaring noise and yellow flame. Could it be a gas/air mixture problem. Thanks.
Hi, I have a large electric water heater, its rusty and leaking at the bottom nr the electrics.
I cant see any numbers but its 680 x 450, big enough for a bath.Im guessing it may be 80L but not sure ?
I cant find the same online, can anyone recommend a reasonably priced equivalent please , its...
Hi all I have a electric water heater and for the last 2 days this box on the flow pipe has been buzzing is this a issue? The box has a lever that’s on auto.
So did a job for a friend yesterday and made (i hope) a small muckup....
Installed a unvented heatrae sadia multipoint 15 but i used plumbers paste on all my compression elbows about 10 of them i only put it on the male threads.
The instructions state that it should not be used as it may...
Hello: I have a year old water heater. About a month ago, I noticed that after somebody takes a shower, I can hear the flow of water (through the WH) when another source of water is being used ie; the water dispenser from the fridge or any of the sinks in the house. The sound coincides with the...
I moved into a property last month and the unvented water immersion heater has been the bane of my life.
I noticed hot water was coming through the tundish so called a plumber out. He replaced the heating element and also pumped up the booster cylinder as it had no charge in it.
2 weeks later...
Hello All, I've got a small leak where the pipe of the hot water outlet of an unvented water heater joins the valve. I'm attaching a couple of photos to give an idea of the set up. Is there a good solution that doesn't involve resoldering the joint? Many thanks.
Anyone seen a valve for a small undersink unvented cylinder that incorporats the pressure relief and expansion that goes out though the hot tap. I will try take a picture tomorrow. Thanks
1579473384
Hi. I bought a house that has a pool heater and the gas line for it is shown here. I also want to put a natural gas garage heater in. My question is: is that piece of pipe coming up where it is capped off where the installer will tie into and go up the side of my garage? That back corner...
I have a cabin about 300' from my well and about 30' elevated from the well. The water heater doesn't work properly. The flow is low through the tankless electric water heater. Is it necessary to increase the flow? If so, how am I able to do that?
I was at a job today and notice a 7litre under sink heater was fitted. Because of the size under 10litres do these not need a pressure relief valve and expansion vessl? It didn't have any of the kind. Thanks.
We recently moved into a new house & the hot water timing is programmed by a Honeywell ST9100A.
I have set the on/off timer OK but am struggling to set it so that it switches on an hour later during weekends ie Saturday & Sunday mornings.
I am wondering if I could ask for some simple advice re...
I need such a spanner to remove a failed IH, and to install a replacement; in a domestic hot water cylinder made by Opus (Cyprus).
I am aware that in general the distance across the flats may vary somewhat from brand to brand, despite all having 1.5" BSP threads.
In my case, both old and new IH...
I’m wondering weather this stringy stuff (see photos) around my towel heater’s pipe joints could be some kind of fiber/string with asbestos in it? They don’t really look like hemp to me, and I’m a bit worried about it! Thanks
Hello,
I would like to have the opinion of professionals. My family owns a house in a village in Greece, where temperatures do not fall below 5-10 degrees Celsius in winter. The house is located in a location where the water supply is not constant and with low pressure (which justifies the...
We are a family of 5, we are not getting enough hot water from our relatively new tankless heater (it fluctuates in heat all the Time and won’t fill up a bath consistently with hot water - can’t support 5 people) . We want to add a water tank to increase amount of hot water available but have...