Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

kitchen

  1. T

    Kitchen sink airlocked

    Hello, My one and half bowl kitchen sink drain seems to be airlocked or blocked, not sure. I've P traps installed, I've to constantly open air vent valve to let water drain. When I open the air valve water drain freely so may be it's not blocked but air locked? I'm attaching image. Any...
  2. Scott_D

    Hole size for kitchen tap

    Would anyone know what the hole size is that a standard kitchen mixer tap requires?
  3. P

    Why the sudden drop in kitchen faucet water pressure?

    Just had strange occurrence and hope someone can please help. Noticed a small leak under kitchen sink. Wanted to troubleshoot shut off valves for possible leak, so I turned them off and on moved them back-and-forth some to check for leak. Nothing. However, upon reopening both supply valves...
  4. beccabeyond

    Shower pump for kitchen tap?

    Can I run a line from my shower pump to my hot water kitchen tap to increase the pressure? If yes, would I call a plumber or electrician?
  5. B

    Different fittings and length on Kitchen sink waste strainer

    Had to replace my kitchen sink waste strainer and have struggled to find a direct replacement. The old fitting is plastic with a screw on top to tighten to the sink. The length is 60mm with a 45mm thread diameter which screws into existing pipework. I shopped around and managed to source a new...
  6. B

    Water pressure in kitchen unbalanced query

    Hi everyone, I have a question about balanced water pressure in my kitchen. Are both the hot and cold water pressure meant to be the same, as my hot water has good pressure when fully open but the cold tap pressure has about 2-3 times more pressure when the tap is fully open almost floods the...
  7. M

    Moving the kitchen to another room

    Hello everybody, i have my eyes on a cheap house, but i would want to change some things. In the picture below you can see all the changes i want to make, but the main concern is the kitchen. Is it even doable to move it like that and what should i consider in such case? I want to have a rough...
  8. A

    Replacing glands on DUAL-LEVER MONO MIXER KITCHEN TAP

    Hi, there is a leak on the hot side of the taps under the lever but I can't see any screw to take out, how do you take them apart if there isn't a screw. Any help would be much appreciated. Thanks
    • Andy uk
    • Thread
    • kitchen mixer replacing
    • Replies: 1
    • Forum: UK Plumbers Forums
  9. B

    Filter fit kitchen sink query

    Hi everyone, I want to purchase the following filter to put under my kitchen sink but am not sure if it will be able to fit the copper pipes as they may be too narrow for the fit. Any advice would be appreciated...
  10. B

    2nd stopcock in kitchen query

    Hi everyone, I figured out what the 2nd stopcock does in the kitchen wall. I ran the cold water tap in the kitchen and turned the stopcock on and off and what it did was control the water flow and even when fully turned off the water was still running albeit at a lesser rate than when fully...
  11. Geolo85

    redo of newly installed kitchen sink and drain line

    Contractor sub installed my new single kitchen sink and garbage disposal wrong. Sub had a "blank slate" with this reno as I made the dining room into a new kitchen. With water running, water fills to top of interior of garbage disposal and then disposal never fully drains once water is turned...
  12. Israrbaig

    Kitchen tap gland 1/4 turn

    My tap started dripping & I used my trusty monkey Wrench & tried to brute force it to turn. Sadly the nut round off & I can’t seem to remove it. I purchased a spanner but still no luck as the nut has no corners. I tried the monkey W again on the base but the metal has turned soft. Any ideas...
  13. C

    Kitchen sink drains slow with Oateys sure vent

    Okay I'm not a plumber and I have those aav Oateys sure vent 20 DFUs and my kitchen won't drain hardly at all now and when I remove it u can hear air rushing in an the water flows great,, now my kitchen an laundry room are close together and above the laundry I see a roof vent, idk what steps to...
  14. T

    Kitchen tap design fault?

    I recently installed a C&L Bilbrough tap from B&Q in a new kitchen. Its the one with a a spout with a switch on it as well as a spray head with switch in additon to the hot/cold mixer/volume control. I have found that if both the spout and spray head are closed off and the mixer valve open...
  15. M

    Kitchen sink minefield

    Hello I'm going around in circles trying to find a new kitchen sink. We want a white one, ideally a more modern look like granite or composite than ceramic. When reading about Franke and peers composite sinks I read a lot of reviews suggesting they feel cheap and plasticky. So... 1) What...
  16. S

    Kitchen Tap Replacement - Nut Size and Adapter

    Hi, I wonder if someone can help - does anyone know the size of this nut/joint and if it will be compatible with the following kitchen tap once I've removed the old one? It seems to have 1/2 and 3/8 Inch Adaptors - will it be a case of unscrewing/removing the the existing pipe and then...
  17. A

    No hot water to kitchen tap only or central heating

    Hi, I require some advice on two issues. I have a Worcester 24cdi combi boiler, my kitchen mixer tap only gets hot water when I turn central heating on. The toilet hot water works without needing to turn central heating on. I recently increased the boiler pressure from below 1 to 1.5, could...
  18. B

    Stopcock no2 in kitchen turn off or keep on?

    Hi everyone, I have a query about two stopcocks in my kitchen. There is one under the sink which turns off the kitchen water, then I have a cold water feed gate valve in a cupboard near my bathroom which turns off the water in the bathroom. However in the side of my kitchen wall there are...
  19. A

    Kitchen smell - cobbled together parts?

    Hi. The house I have moved into last year has had a smelly sink. I now have a chance to look at it and suspect it’s the trap. Dismantling the trap certainly reveals smells further down. I did think it was just an anti-siphon needed. However looking at this again it looks to be a cobble together...
  20. L

    UFH Installation (Existing Kitchen Floor)

    I want to install an UFH zone into the existing floor of my kitchen. Can I channel the existing floor to install the UFH pipe work and back fill with concrete to maintain the same floor level? Also, I’ve seen UFH kits which include a manifold and pump etc Could I just connect TRV radiator valves...

We recommend City Plumbing Supplies, BES, and Plumbing Superstore for all plumbing supplies.

Featured Content

Back
Top