Hi Everyone,
Potterton gold Heat only driving me mad, would appreciate if anyone has any ideas on this one as boiler cutting out after 10-15secs. Phoned baxi 4 times but nothing seems to be working.
Called to boiler not firing, Fault code on LEDS is ignition lockout.
Take cover of burner and...
Switched the boiler off at fused spur then switched it on again. Boiler's working with both heating and hot water but the LED is rapidly flashing red and it won't go off.
Any ideas how to fix it? Tried resetting the boiler and switching it off and on again but continues to flash red.
Thanks
I am a keen DIYer but I don't play with gas! (I am an electronic engineer).
I have an old (25yrs+) Potterton Kingfisher2 that soldiers on but just had it's first major fault - the gas control valve jammed. I ordered a replacement valve on-line and booked a Gas Safe Plumber to come and fix it. He...
Hi Everyone,
Any one know of a good replacement for potterton suprima dimensions wise. got to to replace one 3 stories up so ideally would like to reuse existing flue hole and is fitted in kitchen cupboard, these boilers being very small dimensions i find it hard to find one which retro fits...
Hi Everyone,
I am going to a promax he store which i serviced a few weeks back due to loud noise when heating was on. i cleaned burner replacing burner door seal & flue sensor.
on the 1st visit the boiler was running fine until it modulated to low rate, the flame was not regulating properly...
Just thought I would update from previous post if anyone interested, above boiler had ignition fault, though I got up early and watch boiler until fault occurred right after some gurgling sounds so basically ran HW and CH for a couple of hours, never heard anymore noises and has had no faults...
Yes, I know, get a new one . Fires up (only using HW at mo), runs, burner on say 10-15mins then cuts out (flashing red), hold red, yellow flash once after 3 secs flashes again, after reset will work again sometimes until demand time complete. Think this indicates an ignition fault but if that's...
Hi guys, just after a bit of advice.
Done ppms on two boilers in the title today. All good except both failed to go into ignition lockout.
Called potterton for a bit of advice and they said the PCBs will have a fault and will need changing. It seems a bit odd that both would have the same...
I have a Potterton Promax 15 HE from around 2005.
When I put the hot water on for an hour or central heating, the boiler runs for about ten minutes then shuts off. If I drain the condensate trap using the bung underneath, it runs perfectly for the hour.
I tried draining the trap before putting...
Hi all. Got called to the above boiler which had an intermittent hot water fault. Had it for 2 weeks and gradually getting worse. Went on Friday and couldn't get it to fault. Had it running for 5 minutes and it didn't drop out once. Kept turning tap on and off but still no fault. The customer...
er
OK, so here is an update on this boiler to see if anyone else is the wiser.
I actually got longer than 15 minutes in the property today.
I cleaned out the condensation trap, this was blocked, therefore causing the boiler to lockout. The trap was full of 14 years worth of aluminium by the...
No paperwork - littl' ol' lady with no idea-
She turns the roomstat down at night and then in the morning when she turns it up, boiler doesn't fire, she has to go an reset it, then it works fine again.
Fan is a little noisy/ 'gold' pump at boiler end is quite noisy/ gas supply is 22mB...
Hi
So my system boiler was making turbulent "klanging" noises before intially breaking down.
I had a read up and it was suggested to clean the system. Thus, I can bought some sentinel x800 and after going through the motions(emptying the f&e system, bleeding rads etc) Before dropping the...
Hi Everyone,
I have found a leak on the potterton promax system heat exchanger on top left hand side from a nipple held on by clip, believe it most likely o-ring gone, but i cant find the part anywhere in manual.
I have attached a picture hope someone on here can identify the part?
Thanks
Potterton Gold heat only, I went there last week no heating, 2 jammed trv's and air in the system. I was up against it, it was late and I had 3 jobs ahead of me. Boiler fired up rads got hot, hung around 10 minutes, all good. Tenant reported magnetic filter leaking, put in quote to replace...
Morning Lads and Lasses,
Just been to the merchant to get a diverter cartridge for this boiler had he claims that there is 2 different types ! one with a bypass and one without ? how can I identify which one its is ??? other than taking the cartridge with me ? is there an extra pipe some where...
cant find the spec I need to service this boiler and I'm not planning in making two visits so getting info and parts ready but can't find any info on the nozzel size.Any advice would be appreciate.
Hello,
I let out a small flat and last week, the tenants called to say the potterton boiler did not fire up. I asked them if they topped up the prepay gas meter and it turns out they were on emergency credit. I told them they needed to top it up to get the boiler working again. They did, it...
Hi,
My Potterton Heatmax Boiler is nearly 10 years old, but has been serviced regularly and the Pressure Release Valve was recently replaced. It frequently loses pressure throughout Winter, when the heating is in use. During Summer months, it's fine! All radiators are all heating up to HOT and...
Hi looking for advice went to a job yesterday pressure kept rising and blowing out prv when heating on so I repressurised the ex vessel . I was called back this morning doing the same ,I took the ex vessel out and it was still pressurised also supply pipe to it is clear i renewed the prv which I...