Got a customer with no hot water or heating topped pressure up and was fine on hot water. Put it on heating and pressure goes from 1.2 bar to 2.8 bar in no time at all. I’ve heard about faulty expansion vessels with these. Any ideas? I’m fairly new gas safe engineer and mainly do installs. Any help here would be greatly appreciated, still learning
Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws
View the thread, titled "Baxi neta tec over-pressurising" which is posted in Gas Engineers Forum on UK Plumbers Forums.
Quick run down if it helps you.
I did post there with details on the job because I thought this had been re-posted in Gas engineers only forum page.
I see it isn't and you aren't down as Gas Safe registered?
See Shaun or other mod to gain access.
I see it isn't and you aren't down as Gas Safe registered?
See Shaun or other mod to gain access.
Official Sponsors of Plumbers Talk
Reply to the thread, titled "Baxi neta tec over-pressurising" which is posted in Gas Engineers Forum on Plumbers Forums.
Similar plumbing topics
We recommend City Plumbing Supplies, BES, and Plumbing Superstore for all plumbing supplies.
Thread starter
- Joined
- Member Type
- General Plumber
Thread Information
Thread Tags
- Tags
- baxi