Connecting to cast iron tee

[Matt0029]

What's the best way of connecting 110mm plastic to a cast iron tee after removing the lead? Is it to just clear out the flange on the tee insert the 110mm pvc. Then rope and plumbers mate or silicone?

 

[ShaunCorbs]

Depends on the internal size sometimes you can get a black drain connector in

 

[Matt0029]

Thanks yes I have used the drain connectors before to go in to cast iron pipe but never a cast iron flange/fitting. I will have a look. Q

 

[ShaunCorbs]

Thanks yes I have used the drain connectors before to go in to cast iron pipe but never a cast iron flange/fitting. I will have a look. Q

normal way would rope packed in and cemented over/ infill

 

[king of pipes]

Any pictures?? Of the install

 

[Mdljk]

What's the best way of connecting 110mm plastic to a cast iron tee after removing the lead? Is it to just clear out the flange on the tee insert the 110mm pvc. Then rope and plumbers mate or silicone?

I had this problem a few years ago. I managed to find a fitting that worked like a pan connector. Bellows end went down inside old cast iron stump. Then new plastic 110 slotted into the silicone rubber-ring sealed end. I laid silicone sealant around the plastic end but.... it didn’t take to the flexible seal too well. Was worried I might get some smell but 4 yrs on and daily use I have no problems. If yr interested I’ll search the part out but imo it was basically the same as a straight pan connector only black plastic
[automerge]1595784837[/automerge]

https://www.NoLinkingToThis/p/mcalp...Vi7HtCh00Gw7FEAQYAiABEgL3tPD_BwE&gclsrc=aw.ds