Guest viewing limit reached
  • You have reached the maximum number of guest views allowed
  • Please register below to remove this limitation

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Hive Active Heating Thermostat V3

View the thread, titled "Hive Active Heating Thermostat V3" which is posted in DIY Plumbing Advice on UK Plumbers Forums.

Hi I’m looking to install the above. Atm I have an older one fitted (old wireless thermostat and old receiver that’s wired into my combi boiler. Pic below shows how my current one is wired, live neutral and would the 2x black wires be switch wires and would matter what way they were wired in? My question is when I fit the new hive receiver can I leave existing wiring as is in my boiler and just connect the new receiver to other end of the cable?

Thanks
 

Attachments

  • IMG_5835.jpeg
    IMG_5835.jpeg
    520 KB · Views: 52
Black wires can go either way round, doesn’t matter, but check they’re suitable, as in not open therm. Looks like a Vokéra pcb? Yes can leave existing wiring, provided as I said not opentherm
 
Opentherm is a data language used by some manufacturers, which uses extra low voltage. If they are connected to existing wireless stat, then yes, they’ll be the correct ones.
 

Official Sponsors of Plumbers Talk

Reply to the thread, titled "Hive Active Heating Thermostat V3" which is posted in DIY Plumbing Advice on Plumbers Forums.

We recommend City Plumbing Supplies, BES, and Plumbing Superstore for all plumbing supplies.

Thread statistics

Created
Glasgowman,
Last reply from
Glasgowman,
Replies
4
Views
1,000
Back
Top