radiator in bathroom

[ShaunCorbs]

im looking to get screws for overboarding in my bathroom. any ideas best place to get them and what size i should get for a floorboards at 22mm and 18mm plywood going on top?

cheers

If the flooring is screwed down decent Just enough into the existing

What you overboard get with ?

 

[kakawak]

hi,

im using 18mm wbp plywood then im tiling on top.

 

[ShaunCorbs]

ply isnt the best have a look at hardibacker boards

 

[kakawak]

ive already bought the plywood 🙁

what type of screws and where is best to get them?

cheers

 

[ShaunCorbs]

stainless steel 11/4 or 11/2 long every 100mm

 

[kakawak]

hi guys,

my reactangular bathroom is not equal at the short sides ie window side and opposite door side. it is about 2-3cm out at the window side compared to the door side. i suppose what im trying to say is that it tapers outwards towards the window side if that makes sense. how do i tackle this before i start tiling? do i need to fill one side of the wall or pack it out with a plasterboard?

if i leave it as it is, i will no doubt have issues with squaring this off when i do the floor. any ideas on how to remedy this situation is most helpful 🙂

cheers

 

[kakawak]

update on floor.....it looks like i have a slight dip in the middle of floor after i have screwed the plywood down...

should i use a self leveling compound? i would say the dip is about 3mm when i use my level across the floor. is there a tolerance for dips or will the tiling adhesive make up the shortfall?

cheers