Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Install the app
How to install the app on iOS

Follow along with the video below to see how to install our site as a web app on your home screen.

Note: This feature may not be available in some browsers.

Aug 23, 2014
23
6
3
Very little water flow from any ‘hot’ tap in the house i.e. bath tap, bathroom sink tap and kitchen tap; just a slight flow that stops after a minute or so. Been working fine but virtually stopped flowing this morning.

The house has a conventional vented CH system with a cold water storage tank in the loft and a hot water cylinder (with immersion heater) in the airing-cupboard.

The 22mm outlet feed pipe from the loft tank to the hot water cylinder isn’t blocked at the loft tank end; had a thin copper rod down a few inches and a had wriggle about ,but no joy.

Any thoughts where the most likely blockage point will be? I’m assuming (maybe wrongly) that debris of some description has entered the system.

All advice gratefully received.
 
could be air,
a wet vac on hot tap could sort it either way.

could be somthing has gone down the cold pipe and is stuck at a bend??
or an issue with the isolation valve on the cold pipe down to the cylinder.

I would progress the search to that tap, close it, open hot taps, undo bottom fitting to valve, lift pipe clear from valve, with a bucket ready open valve and see.
(assuming a valve is fitted and working!)
 
  • Like
Reactions: 2 people
OP here; many thanks for the replies..

I’ve just found out that the loft water tank also supplies the ‘cold feed’ to the bathroom power-shower; .....so maybe the loft tank did run dry and an air-lock has been introduced ??
 

Official Sponsors of Plumbers Talk

Similar plumbing topics

We recommend City Plumbing Supplies, BES, and Plumbing Superstore for all plumbing supplies.