Undermounted sink, what bits and bobs needed ?

Raff · Mar 3, 2016

Gotcha guess all it takes is one washer to break to leak, so far I have fiddled around here and there and come up with this:

http://i68.tinypic.com/10xbi10.jpg

Not sure if it looks good or not !

I think I just need one more 90 degree bend on top or perhaps an adjustable compression bend which I have, since it does feel maybe I have to get it at a slight bend I guess you can only do it fully once the worktop and sink is in the final position so will wait for plaster to dry, hopefully otherwise it looks doable I hope lol

ShaunCorbs · Mar 3, 2016

perfect top banana, just dont forget the overflow from the sink before you test it 😀

Raff · Mar 3, 2016

Will let you know how it goes once this darn plaster dries in few days time hopefully, thanks for all the advise Shaun, Riley and all🙂

Raff · Mar 18, 2016

Just wanted to say thank you all especially Shauncorbs, got my sink up and running in the end.

The push fits and compression 90 degree an 135 degree bends and 40mm push pipe came into full use. Have taken several pictures of what goes underneath and outside so hopefully never have this issue again in my life time.

Had a leak on my water tap connector but then tightened it up to the end but not too much and it stopped and its been golden with no leaks for a week now, and it sure beats washing the dishes in the bath tub !

Respect and faith in plumbers restored somewhat !