You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
vented
The red-vented bulbul (Pycnonotus cafer) is a member of the bulbul family of passerines. It is a resident breeder across the Indian subcontinent, including Sri Lanka extending east to Burma and parts of Bhutan and Nepal. It has been introduced in many other parts of the world and has established itself including New Zealand, Argentina, Tonga, and Fiji. It has also established itself in parts of Samoa, Australia, USA and Cook Islands. It is included in the list of the world's 100 worst invasive alien species.
Hi All,
I'm a customer looking to have about 40 square meters of UFH in a new ground floor extension.
The current central heating system is an old concorde with primatic cylinder that I was going to have to replaced with a Worcester 30CDi Classic, new vented cylinder and heating header tank...
Hi All,
Quick question. Customer had en suite fitted with toilet soil pipe running out side of roof over guttering across about 6 m and teeing into existing soil stack on side of house. This then runs another 4-5 m into the vented pipe. All in all the en suite WC has a run of around 13 m. It...
I would to change hot water system in my flat and the only solution plumbers give me to get rid of cylinder+tank is vented cylinder (I want also have more space into the storage that's why I do not want another unvented system). I have only electricty at the flat.
My question is, assuming the...
gijno
Thread
another
cylinder
installed
safe
unvented
ventedvented cylinder
Hi guys, i am not too clued up on open vented system layouts and fault findings so any help will be much appreciated.
a friend contacted me to say some of there rads where not heating and they regularly had to bleed the rads on the top floor (3 floor house) i was rushing to another job but...
long-pass
Thread
bleed
central
cylinder
heating
open vented
system
vented
Hello everybody. Could somebody please tell me why it is necessary to offset the vent pipe by 450mm directly off the top of an open vented cylinder. Iv heard its to "prevent one pipe circulation" what exactly does that mean? Thank you.
Dannyparty92
Thread
can't
cylinder
heating
offset
open vented
something
vent
ventedvented cylinder
Hi
I did find quite few threads on this already here but not one that answered my question.
I have a 2 story-semi with 2 existing upstairs toilets currently discharging into a singe exterior vented stack.
I am fitting a new WC in downstairs cloakroom and am intending to run the new waste...
Hi, I'm new to this forum so please bear with me.
I recently bought a house and have an old open vented system installed. The problem with it is that the boiler keeps overheating and shutting down for a while to cool down. I think it's due to poor circulation. The pump seems ok so I suspect...
Mondrota
Thread
after
between
flow
flow and return
pump
return
system
valve
vented
I am about to replace the leaking indirect, vented hot tank in the domestic central heating system. I would like to fit a 125 Heatrea Sadia Megaflo tank in the non-pressurized system. The hot water supply is not pumped. Is this possible? Is a pump required? And if so where should it be fitted...
Hi Fellas,
Im new to this site and have a question???!
When converting an open vented system to a sealed system (expansion vessel, PRV and all the rest) can I connect into either of the primaries?
The boiler is located in the garage and would be an ideal place for me to site the expansion kit...
Hi Everyone,
Just a simple question that might get a host of replies. Can anyone tell me is it better (or cheaper) to leave your hot water on permanently? I have a condensing boiler with a stored water cylinder.
Regards
DEMPSEY1965
Hi everyone,
I'm a new member and not a plumber or central heating engineer.
Mum and me live in a 1970 house she's had from new and the installed central heating is very primitive (no thermostats except the one close to the Concorde boiler, no zonal valves). As far as I know, it's never been...
rick
Thread
change
microbore
old
open vented
piping
should
system
vented
year
Good morning, I have been asked by a customer to increase the power/ flow of his shower.
The current installation is main feed electric 8.5kw shower. I haven’t tested the main pressure at the shower as yet but let assume it is 1.5 bar. The heating is a vented y plan gravity system. The bathroom...
I have an open vented sytem and when the boiler knocks off a moaning and groan goes through the near by pipes. Can anyone point me in the right direction?
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.