Hanging heavy rad on plasterboard wall

[bright spark]

Lads did d guy not say d rad was 35 kg weight with no water. I don't think ye'd b hanging that on plasterboard. Personally I'd b putting rad brackets directly on joists if builder could organise or screwing a bit of 12 mm ply to wall joists and securing rad to that. But I'm open to suggestions

 

[wetdrip]

Lend us your new samsung camera then

I'm still running on tape.

 

[cr0ft]

Lads did d guy not say d rad was 35 kg weight with no water. I don't think ye'd b hanging that on plasterboard. Personally I'd b putting rad brackets directly on joists if builder could organise or screwing a bit of 12 mm ply to wall joists and securing rad to that. But I'm open to suggestions

No problem at all. Each of those anchor fixings is good for 20kg so with 4 that's going to be 80kg. Plasterboard is incredibly strong in shear i.e. up and down forces across it's face. Try pulling it apart and you will see 🙂 There is next to no force pulling it out from the wall as 99% of the weight of the rad is acting downwards. If nervous then use 6x anchor fixings for 120kg hold strength.

Joists are obviously a better solution but I wouldn't be worrying about ripping open a wall to hang a 35kg + water rad tbh.

 

[R.Oak]

Ive always found decent plasterboard fixings and some 'sticks like ****' does the job. If you really are in doubt cut a hole, insert some batton and screw through into it so that the rad bracket and batton and being pinched up tight through the plasterboard.

 

[SimonG]

My favourite at the moment is to cut an offcut of grant westfield panel, smaller than rad. Screw this into studs, white side out, and then hang rad on that using the short projection side of bracket. Once its on you cant see it.