Jacuzzi toilet seat fixings are loose and I cannot figure out how to tighten them. Nothing seems removal and they cannot be accessed from underneath. Can anyone please advise me how to tighten them? Many thanks and warm regards
Hi folks,
Might be a stupid question but I currently have a wet room shower in place with a waste trap but I am looking to convert to a shower tray with raiser kit.
Is there an easy way to connect shower waste from tray to wet room trap using an adapter of sorts? I am trying to avoid ripping...
Hi guys, I’ve got a close coupled toilet wher the waste come out of the back of the toilet then it’s a 90 degree bend to the right where it goes off through the wall. However with the 90 degree pan connector pushed into my soil pipe, the pan connector end isn’t long enough to reach the back of...
Hi all
Relatively inexperienced homeowner here. Apologies in advance if I get any terminology wrong.
Today I noticed some limescale accumulation on/around the grout between the floor tiles next to my toilet. I realised that the grout line right next to the toilet was in fact wet to the touch...
I have bought a replacement 1200 shower door & 1200 x 900 tray, ready for a refurb starting soon.
The current door & tray is in a recess, which measures 1200 x 900, but these measurements include the current tiles, which will be replaced. I now see that the new door has a tolerance of...
Hello
I have a salon and the plumbing for the hair wash basins is taken from the toilet, so when we are washing hair and the water is a good temperature, when the pump goes the water goes cold it takes a wile to come back. It used to do it a bit and now its much worse.
A plumber said it cant be...
Hi
My thermostat shower is leaking at the temperature position. How do I fix it, there's a grub screw underneath which i have already taken out, not sure what to do next?
Many thanks
Keen amatuer that I am I decided to have a go at changing the cartridge in my shower when the old one failed. I had a spare as I got one when I had the valve fitted. The cartridge is as a SC50T32 I followed the video on the Ultra technical site l and it all went smoothly but I now have a...
Installed a victorian plumb shower valve and tested last night, on and off no problem. Tested againg tonight and it came on but wont switch off.
Contacted victorian plumb and have to wait up to 72 hours for a reply.
Any ideas on what I can try as weve been without a shower for over a week now...
Hi folks, sorry to have to post this but we got a new bathroom a few months ago and the toilet seat was loose at one side. The cistern is integrated and the seat is top-fixing. I assumed it was quick release but couldn't find a button to push, there are no little grommit hidden screws or...
Hey, I'll start by saying I'll be getting a plumber out to do this but wanted some advice first. We're redoing our ground floor bathroom this year and want to move the toilet to another wall as part of that. I've cracked open the boxing around the old toilet today to see what's going on behind...
Hi!
Hoping for a bit of help!
Thought I had an easy job of changing my toilet seat however it seems to be more challenging than I thought.
It seems there’s no screw under the chrome. Just one long screw with a wing nut underneath. Please correct me if I’m wrong. The toilet seat also doesn’t...
At our wits end. Remodeled a farm house in 2020, installed the water heater and due to appliances being backordered couldn't move in until Nov. of that year. After a hot shower we noticed a terrible smell. We had the lines smoked, venting tested, used a camera on the lines, all from a local...
Hi - planning a bathroom renovation - I've been overwhelmed by the amount of wetwall types (acrylic, plastic, laminated mdf) and from hundreds of manufacturers. Could any of you pro's give me your opinion on which manufacturers and which type is the best to use. Much appreciated - John.
I installed Jaquar Fusion thermostatic bath shower mixers during a conversion in 2007. I let the properties out. They have lasted pretty well with the thermostatic and diverter cartridges needing replacing every now and again - some are possibly still the original. Can't really complain about...
Can someone please give me a bit of advice here. My hot tap has slowly been twisting the wrong way in recent months. Now it's finally against the wall. I don't want to switch it on for fear I won't get it back off.
The bath is basically attached to the wall so it's next to impossible to get...
Hi im just starting new shower in our new extension. Its a concealed thermostatic mixer from victorian plumb, no instructions.
Im putting the valve in a false wall which has been plastered, I pre installed the hot and cold feed and have just opened the box with the shower head.
It has a...
Hi,
I just bought an old house that was renovated in the 1980s. The bathroom shower has some kind of valve on the supply pipe - does anyone know what this is for? The whole bathroom will be going into a skip in a few months but I’m just curious as to what it’s for.
Thanks.
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.