Questions and plumbing advice in the Bathrooms, Showers and Wetrooms - .
Some popular plumbing forums: Plumbing Advice - Plumbing Tools - Plumbing Courses & NVQ's
Need a section on here that covers showers.....
have a Milano Elizabeth shower mixer, often...
I came across this thermostatic cartridge and was wondering if you could help me locate a...
Hi,
I am more or less a complete novice when it comes to plumbing and I need help identifying...
I’ve paid good money for a bathroom installation. This follows on from having an en-suite...
I seem to find a lot of different opinions on fixing walk-in shower trays to floors. I will be...
Hello
I am trying to identify a jacuzzi / whirlpool / spa bath so that I can replace the drain...
Anyone know where I can get a 700 x 600 shower tray, riser leg set and single door ?
hi all
so, currently i have a rear feed shower arm and a rainfall head. is there any connector...
On bad advice our builder installed a no brand/cheap built in shower mixer in our new bathroom 5...
First time novice, I thought I had a problem with my shower pump as the flow was much lower than...
Hi, I am fitting at Stuart turner shower mate eco 1.5 bar.
My question is, can the inlet be...
this may sound a basic question, but it is important. I have seen so many conflicting opinions...
We have a shower on a gravity fed system that isn't quite powerful enough to provide an...
Hi. For the first time since moving in 7 years ago, my pre-existing bath hot tap is only running...
Hi, I'm about to buy a thermostatic shower and decided on the Hansgrohe Crometta 240. On Amazon...
I ordered a McAlpine 90mm x 50mm shower trap for my walk-in shower. The base will be 18mm ply...
I am ready to waterproof my walk-in shower ready for tiling. The walls are Aquapanel sheets...
Hello,
I’m trying to fit a diverter to a Grohe concetto single hole mixer tap. I have removed...
Hello.
Installing a shiny new Hudson Reed shower in France...
The shower comes with two stem...
So many of you guys fit this size tray? I’ve always thought 700mm is a bit of squeeze to be...
For some reason I'm not getting hot water coming out of the bath tap it's just coming out warm...
I have a traditional British bathroom sink with 2 separate taps for cold and hot water. I need a...
Hi everyone,
I hope someone can help thanks.
I have had a new wet room installed and overall...
Hi all. It’s been a while since fitting a bath for a customer but I’m looking for some solid...
I have what appears to be a little used bath taps/mixer with shower outlet, without connecting...
Hi there I hope you can help
The clip on the top of my bi fold shower door has snapped so it...
My mixer bar shower gave up the ghost on its thermostatic mixer valve, so the water wouldn't...
I'm struggling to find advise on my set of circumstance here, I'm moving into a new flat and it...
my shower is leaking, but cant find and screws at all except 2 nuts on the handle, anyone know...
For a while now I have struggled to get a down light that ticks all the boxes I have now found...
Finally got round to ordering the matetials that i will need for the job and have settled on the...
Can anyone suggest a thermostatic mixer shower that can be piped from above with exposed...
While changing the posi-temp cartridge in one of our Moen shower faucets, I noticed a tee...
Hi guys any one experience wirquin shallow traps?! Great design.
I’m having an issue for the...
Hi, I've got a problem which I can't see a solution to, a future customer of mine wants to add a...
Are there any dual lever shower taps/regulators, which I can install behind my shower wall ...
I have a grohe 800 bath/shower mixer and Grohe pillars to deck mount them but am unsure about...
So I have a question here and I’m completely lost, I had a shower screen replaced as it...
Fitted one for a customer in 2012, she requires a new bath panel but they are now discontinued...
Hi all,
This may be a slightly lengthy one, but i'm having a seriously rough time with a bad...
Hi
Many years ago a builder installed my Gainsborough ambassador shower...
Hello...
I have a Hudson Reed shower to install but don’t get this...see picture below..
The...
HI,
Looking for some guidance on buying and fitting the right products.
I currently have a...
It looks like that over time water has got under the seal of the bath tap and has rotted away at...
Hi,
We have a shower like the atatched pic with Bristan 1901 on the cap...
Hi,
Our 5 year old Saniflo (Saniplus) triggered the house electrical circuit breaker. I reset...
Are roca vanity units a decent standard? Need one with draws and with legs at the front. Roca...
Hi,
I have installed a salamander pump for my shower. I primed both sides of the pump before...
I can’t get to the nut as it is in the mixer bar - is there a tool to use?
Thanks
Steve
Newest Plumbing Threads
-
Air inside ideal Logic 24 boiler system
- Started by Turbotim
- Replies: 1
-
What's the most convenient way for me to plumb drainage channel?
- Started by Instadeth
- Replies: 1
-
-
Y Plan central heating gets hot on hot water demand
- Started by MPGASANDPLUMBING
- Replies: 1
-
Grant boiler rusting inside after 1 yr
- Started by RayPlumb
- Replies: 10
-
Instructions say to apply glass cement to rubber washer. Can I use silicone?
- Started by JM Tiling
- Replies: 2
-
How do I remove the copper pipe from the plastic connector?
- Started by JM Tiling
- Replies: 2